X-T5
Your X-T5 is tested and verified to work with our app. Download it, plug the camera in over USB or drop in a photo, and you'll get a result.
Buy a licence to see your result.
Licences start from $5.99
Requires Windows 10 or 11, or macOS 11.7.11 or later
Successfully tested on camera firmwares
- 4.21
- 4.31
X-T5
Shutter count
Compared
Right in the middle of the pack.
Get your shutter count
USB direct read
Connect the Fujifilm X-T5 to your computer with a USB cable and the app reads the exact actuation count straight from the camera.
- 01Before checking, set the camera to still-photo mode, choose NETWORK/USB SETTING > CONNECTION MODE > USB TETHER SHOOTING AUTO, and check that NETWORK/USB SETTING > USB POWER SUPPLY/COMM SETTING is set to AUTO or POWER SUPPLY OFF/COMM ON. Turn the camera off. Connect a USB cable. Turn the camera on.
- 02Connect the camera to your computer with a USB data cable, straight into the computer rather than through a hub, and turn the camera on.
- 03Open Camera Shutter Count and go to Check.
- 04When it shows Connected via USB, select Check.
- 05The count appears in the result card.
EXIF file drop
Drop any unedited photo from the Fujifilm X-T5 into the app and it reads the shutter count from the file's metadata. No cable needed.
Note: the count in a Fujifilm X-T5 photo can reset. A Fujifilm photo can only show a count up to 32,767. Then the count starts again at 0. Your Fujifilm X-T5 keeps the full lifetime count in the camera body. For that count, use the USB read.
- 01Find any original photo from the body (not re-exported).
- 02Drag it onto the Check panel.
- 03The count appears immediately.