X-Pro2
Your X-Pro2 is tested and verified to work with our app. Download it, plug the camera in over USB or drop in a photo, and you'll get a result.
Buy a licence to see your result.
Licences start from $5.99
Requires Windows 10 or 11, or macOS 11.7.11 or later
Successfully tested on camera firmware
- 5.11
X-Pro2
Shutter count
Compared
Well used. Most others have shot less.
Get your shutter count
USB direct read
Connect the Fujifilm X-Pro2 to your computer with a USB cable and the app reads the exact actuation count straight from the camera.
- 01Before checking, set the camera to still-photo mode and choose SET UP > CONNECTION SETTING > PC CONNECTION MODE > USB TETHER SHOOTING AUTO. Turn the camera off and connect a USB cable as shown, making sure the connectors are fully inserted. Turn the camera on.
- 02Connect the camera to your computer with a USB data cable, straight into the computer rather than through a hub, and turn the camera on.
- 03Open Camera Shutter Count and go to Check.
- 04When it shows Connected via USB, select Check.
- 05The count appears in the result card.
EXIF file drop
Drop any unedited photo from the Fujifilm X-Pro2 into the app and it reads the shutter count from the file's metadata. No cable needed.
Note: the count in a Fujifilm X-Pro2 photo can reset. A Fujifilm photo can only show a count up to 32,767. Then the count starts again at 0. Your Fujifilm X-Pro2 keeps the full lifetime count in the camera body. For that count, use the USB read.
- 01Find any original photo from the body (not re-exported).
- 02Drag it onto the Check panel.
- 03The count appears immediately.